"Are there any suitable propane fittings that would be safe to use and > quick to connect/disconnect?" Yes. The propane hose going to my catalytic, mounted on the battery bulkhead behind the psgr seat, is a removable quick release fitting hose that goes from the bottom of the sink cabinet. The hose could be any length and since it's rubber it can be bent in any direction to snap/plug into the heater. Mine goes along the floor in that seam between the floor and bulkhead. By the way, I notice the heater in the pic is mounted in the table bracket. If you like you can apply that same bracket to the psgr seat bulkhead so that application can be used over there. It occurs to me that Terry K's foot-step device could be used and modified to mount the heater on. His foot step slips into the front table mount to help volks get into the upper bunk. bob |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.