Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2005, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 2 Oct 2005 21:24:28 EDT
Reply-To:     THX0001@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         George Goff <THX0001@AOL.COM>
Subject:      Re: Hacksaw to remove upper nut for front shock?
Comments: To: rrecardo@WEBTV.NET
Content-Type: text/plain; charset="US-ASCII"

In a message dated 10/2/05 7:11:43 PM, rrecardo@WEBTV.NET writes:

<< DYK that there is a socket that actually fits the top of the shock shaft? >>

Oh Great Disseminator of Arcane Wisdom,

There is also a deep socket with flats around its top and bored out to accept another socket. On its working end the "inner" socket engages the flats of the shock shaft and its other end has a square drive for a ratchet. I have a kit like that with different sized sockets for the nuts and differently configured drivers for the shafts.

Georgie Boy


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.