Date:         Thu, 13 Oct 2005 14:47:35 -0600
Reply-To:     bueses <bueses@EARTHLINK.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         bueses <bueses@EARTHLINK.NET>
Subject:      Re: Propane quick release parts for heater
Comments: To: Aaron <lists@MYCOMMUNITYNET.NET>
In-Reply-To:  <C56F65D4-CEAE-4198-A52D-FABC68E10246@mycommunitynet.net>
Content-type: text/plain; charset="US-ASCII"

>The only issue I am running into is finding the proper fitting. I
> found a quick release at the local gas place and it's $70! A bbq one
> is cheaper, but not meant for use in the hose. Has anyone here done
> this, and if so, what kind of fittings/setup did you use?

 I did this as you are describing +-(see pics I sent you earlier) & the
quick release shown in the pic was only $30 +- at a big lp gas place.

Tom

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.