Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2005, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 21 Oct 2005 14:46:05 -0400
Reply-To:     tabe johnson <xtabe@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         tabe johnson <xtabe@YAHOO.COM>
Subject:      Oil Fill Level - Only go halfway.  Makes a difference!  Thanks
              Dennis.
In-Reply-To:  <20051021181036.61038.qmail@web30708.mail.mud.yahoo.com>
Content-Type: text/plain; charset=iso-8859-1

I just said this in another message but I've been meaning to post my results to the list for a while.

Any chance he can, Dennis Haynes quietly points out that you should not fill your oil to the upper line on the dipstick. Dennis, who (as usual) knows what he's talking about, should be shouting from the rooftops!

With oil at the "full" level, the crankshaft whips it into foam. (mmm, foam!) The oil pump is then pumping oil and air, not just oil.

I accidentally verified this:

Our oil pressure, at HOT cruise (>3500RPM for 30 minutes at the very least) was around 32 PSI with our UH (Unknown History) 2.1 engine, oil level at the halfway point. With our van parked on a slight slope, I checked the oil. It was down to "min" so I filled it to the halfway point. After that, our oil pressure in the same conditions was perhaps 28 PSI. Freaked me right out!

I checked the oil level in a flat parking lot and sure enough it was at "MAX". Oops. Since we were on a trip, I had to get a bit creative. To lower the oil level, I removed one valve cover and let the engine idle. The oil dripped out of the head into the valve cover + newspaper I'd put on the ground below the head . I disposed of the oil in a crystal clear sparkling mountain stream and put the cover back on. (I removed ~400mL, but the level as indicated by the dipstick was juuuust under "MAX". So the dipstick evidently does not read in a linear fashion.) Anyway, my pressure went back where it had been.

Want a bit more oil pressure for free? Lower your oil level to halfway, while measured on FLAT ground.

tabe johnson/87 westy


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.