In a message dated 10/27/05 1:08:04 PM, kayakjr@JUNO.COM writes: << Soory - thought the title said it all! It's for fuel lines - the 7mm ID ones that feed fuel from tank to the injectors Clamps are specified by diamter (typically a range). >> John, The subject line does say it all . . . if it's read. The fuel hose is 7 X 3 mm, so its OD is 13 mm. I've used the smooth-band, machine screw type hose clamps for this application in two different sizes: 11.0 - 13.3 mm (7/16" - 17/32") and 12.0 - 14.3 mm (15/32" - 9/16"). I found both sizes to work, only the larger will slide over the bulge in the hose caused by the barb on the fitting without undoing the screw of the clamp. George |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.