Date:         Sat, 29 Oct 2005 00:12:48 -0400
Reply-To:     Benoit <huotb@VIDEOTRON.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Benoit <huotb@VIDEOTRON.CA>
Subject:      Re: Give me some feedback here!!!!
Comments: To: Paul Guzyk <paullist@guzyk.com>
In-Reply-To:  <a06020400bf87df5f552c@[192.168.102.100]>
Content-type: text/plain; charset=ISO-8859-1; format=flowed

Thanks Paul.... but of course the nipple is a perfect fit... now the
problem is a broken torque/tranny oil pump seal, so the torque converter
is "spitting" oil all around.... Grrrrrrrrrrrrrrrrrrrrrrrrr.....

Story is that the lady had a heavy tranny oil leak, driving with a oil
level to low, torque converter failure, broken plate from a vibrating
converter and worn bushing.....
New plate, bad T-converter and pump bushing... second failure....  now
me! good plate and new converter but a worn seal (done with the bad
converter).....

I need to remove the tranny again and change that seal....

Bum!
Ben

Paul Guzyk wrote:

> Make sure the "nipple" in the center of the torque converter has
> absolutely no rust on it.   Test fit the flex plate when everything is
> out of the car...the flex plate should go on easy over the nipple.
>
> Use a wire wheel on the nipple if you have to.
>
> If it is too tight a fit, the flex plate may not seat correctly when
> you tighten it down, this puts extra stress on the flex plate and
> could make it more susceptible to breakage.
>
> Replacing the torque converter is also a good idea at this point if
> she has broken two flex plates already.
>
> -Paul
>
>
>
>
>
>