Date:         Sun, 30 Oct 2005 12:39:57 EST
Reply-To:     THX0001@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         George Goff <THX0001@AOL.COM>
Subject:      Re: Any Clutch Slave Cylinder Secrets?
Comments: To: Tom@SALICOS.COM
Content-Type: text/plain; charset="US-ASCII"

In a message dated 10/29/05 10:08:38 PM, Tom@SALICOS.COM writes:

<< Is there a smart way to R&R that thing? >>

I reformed a twelve point box end wrench into one with a very deep and steep
offset specifically for that job.  I think I thinned the head of it a bit,
too.  Also, I recall attacking the damn thing from underneath.

George

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.