same old story hold down tabs on cluster busted off some of the screen sink for the odo-meter sheared off I have had good experinece with permatex plastic weld but never tried to fabricate/mold things a tiny as the hold down tabs has any one tried it would be worth the effort will the permatex take drilling & tapping after building it up enuff for the screw sink for the odo |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.