Date: Wed, 2 Nov 2005 21:02:40 -0800
Reply-To: Shawn Wright <swright@ZUIKO.SLS.BC.CA>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Shawn Wright <swright@ZUIKO.SLS.BC.CA>
Subject: Re: Axle flange sloppiness
In-Reply-To: <009c01c5dfd6$654ba9a0$6401a8c0@daryl01>
Content-type: text/plain; charset=US-ASCII
Darryl,
Thanks for this info, now I understand things a bit better - I also studied the EKTA
diagrams to see how all the pieces go together. The driver side has more play,
possibly because the inner CV was nearly seized due to hardened grease. I imagine
this would place more side forces on the flange spine joint causing more wear?
Transmission was very quiet, so I think bearings are fine. I'll watch the seal for
leaks.
On 2 Nov 2005 at 9:53, Daryl Christensen <aatransaxle@DIRECWAY.COM> wrote:
> Shawn...Do not tighten the "big nut thingy" on the side...
> The nuts are for backlash and preload of the Ring/Pinion and usually do not
> affect anythng you can feel on the flange. There is always some bit of play at
> the flange and some of what you might feel is internal diff gear wear. Any up
> down movement will eventually cause a seal leak but in/out movement wont usually
> hurt anything. If your diff bearings are worn enough to cause play, they would
> likely be noisey...The pass side flange usually has more play than the other
> side due to the diff construction and wear patterns. Daryl of AA Transaxle
> Duvall, WA. (Seattle area) 1-877-377-0773 toll free 425-788-4070 aatransaxle.com
> 86 Syncro Westy WBXTurbo
>
> ----- Original Message -----
> From: "Shawn Wright" <swright@ZUIKO.SLS.BC.CA>
> To: <vanagon@GERRY.VANAGON.COM>
> Sent: Tuesday, November 01, 2005 5:09 PM
> Subject: Axle flange sloppiness
>
>
> > When encountering a 4 speed transmission with one axle flange that has
> > some
> > side play (driver side only), but no other symptoms of problems (good
> > shifting, perfectly quiet), is there a recommended fix?
> > Can I tighten the big nut thing around the flange without screwing up
> > other
> > things, or does this nut only affect the preload on the ring & pinion?
> > What
> > are the dangers of leaving it alone - leaks, bearing wear?
> >
> > thxShawn Wright
> > http://zuiko.sls.bc.ca/~swright
> > '85 Jetta D
> > '88 Westy 1.6TD 5 speed
> > (see progress at http://members.shaw.ca/vwdiesels)
> > '82 Diesel Westy
> >
>
Shawn Wright
http://zuiko.sls.bc.ca/~swright
'85 Jetta D
'88 Westy 1.6TD 5 speed
(see progress at http://members.shaw.ca/vwdiesels)
'82 Diesel Westy
|