Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2005, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 7 Nov 2005 07:57:34 -0800
Reply-To:     Michael Diehr <md03@XOCHI.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Michael Diehr <md03@XOCHI.COM>
Subject:      Re: Help diagnose Cinco
In-Reply-To:  <vanagon%2005110710192053@GERRY.VANAGON.COM>
Content-Type: text/plain; charset=US-ASCII; delsp=yes; format=flowed

> Am I right in assuming that on a 4-stroke engine like this, the TDC > mark on the pulley turns at the speed of the crankshaft, so there are > only two possibiilties (either correct, or 180 degrees off)?

To clarify: By "180" I meant the distributor drive shaft would be 180 degrees off. The crank would be 360 from TDC (i.e. TDC, but on on the intake stroke rather than power stroke). The distributor drive runs at 1/2 crank speed, yes?


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.