On 11/9/05, John Rodgers <inua@charter.net> wrote: > > I am ready to install a new O2 sensor in my van, and it is a Bosch > single wire type. > > Can anyone tell me how to wire this thing. There are three wires coming > to the old sensor, which is a three wire sensor type.
I'm guessing you have the newer 3-wire sensor (if it's a 1-wire and u need help...hoo boy!). I just put a new bosch 3-wire on my own myself. Cut the wires off the old sensor. Cut 'em off close to the old sensor so you have plenty of length. Now get out the new sensor. The two white wires on the new sensor are the heater. They connect to the two wires on the rectangular connector. Polarity doesn't matter. Butt splice those together. The black wire goes on the remaining wire, with the single rubber booted spade connector on the end. That's all there is to it! Before splicing anything, you may wish to slip a length of shrink tubing over the wires to cover the splices.
-- John Bange '90 Vanagon - "Geldsauger" "We'd tell a monkey how to peel a banana, if he said he was peeling one in a Vanagon." |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.