Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2005, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 8 Nov 2005 16:31:12 -0800
Reply-To:     mark drillock <drillock@EARTHLINK.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         mark drillock <drillock@EARTHLINK.NET>
Subject:      Re: venting, was Re: dometic 182b question
In-Reply-To:  <vanagon%2005110812351356@GERRY.VANAGON.COM>
Content-Type: text/plain; charset=us-ascii; format=flowed

The RV diagram shows the burner exhaust area all right. The burner heat and gases exit into the upper area behind the fridge same as the heat from the fins. That is part of why the design of the chimney is so important in that particular discussion. Our Westy fridges have a separate combustion venting system is not used by most RVs so the hottest air goes right out our vent tubes.

The Westy fridge combustion vent system is superior from a practical stand point. It keeps all the dangerous combustion byproducts completely outside. It does so without an intake vent low on the outside of the vehicle like RVs have. It does so without an exhaust vent high on the outside. Imagine how much worse the rust problems would be on that side if there where 2 large always open vents on the side, like most RVs have.

Removing the insulation behind your fridge was a mistake IMO. The insulation helps keep the heat from the sun from overheating the area behind the fridge. Whenever the sun shines on that side for very long the fridge cooling fan can be triggered even with the fridge off.

What I and others have done is to install a fan that vents the hot air from behind the fridge to the outside. My main problem is my fridge keeping food too cold unless I adjust the temp setting. I recent camped for 12 days in Baja, days in the 90s, nights in high 70s and low 80s. The fins inside my fridge were a solid block of ice that grew larger every day.

Mark

Roger Sisler wrote:

>These diagrams all imply, as well as I can tell, that the waste heat is >contained into a vent that will exit the roof.The actual burner heat and >vent is not shown here.In the vanagon, this waste heat is all contained >until it exits the grill behind the stove-and then goes into the pasenger >compartment.All I did was to keep as much burner heat as possiable in the >vent pipe where it belongs so it can exit the van completely. I think the >heat from the fins is will stay in the interior unless it is seperately >vented somehow. I did this by removing the fibgerglass insulation on the >van wall.I hope someof it will conduct out. > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.