Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2005, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 19 Nov 2005 16:22:54 -0500
Reply-To:     Roger Sisler <rogersisler2000@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Roger Sisler <rogersisler2000@YAHOO.COM>
Subject:      Re: uh oh ! rear heater bleeder screw broke off.

John Meeks-- I fixed the problem.Thanks for offering the new bleeder valve screw,but I dont need it anymore.The security of knowing that it was avaliable prompted me to go ahead with my screwectomie. The correct bolt size is M10 with a 1.0 thread pitch( for the archives). I would suggest a bolt shorter than 20mm.I would rather have this bolt cause it wont break. I think I will leave off the rear heater cover as it will give a few more cubic inches of storage space. With the bolt,I dont have to fear that shifting of cargo will break the bleeder screw.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.