> I bought a Bosch 13913 three wire oxygen sensor. I am preparing to cut > the > end off and solder the VW end in its place. Does anyone have the wiring > schematic for this procedure? > Nothing to it, just match colors. Two white wires on the sensor go to the two whites on the two pin connector, black wire to the black wire on the single rubber booted spade connector that carries the signal. The white wires are just the heater circuit and don't care about polarity. -- John Bange '90 Vanagon - "Geldsauger" |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.