Jere There are three wires. Cut off the plug and strip back the wire ends. The one with the stainless steel wire core is the OXS signal wire. This goes to the single OXS spade plug. The other two are the heater wires (0v and 12v). These connect to the double OXS plug. BTW it is almost impossible to solder the stainless steel wire. I gave up and used a screw connector. Hope this helps. Larry <<I bought a Bosch 13913 three wire oxygen sensor. I am preparing to cut the end off and solder the VW end in its place. Does anyone have the wiring schematic for this procedure?>> |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.