Date: Wed, 23 Nov 2005 17:25:51 -0800
Reply-To: Jake de Villiers <crescentbeachguitar@TELUS.NET>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Jake de Villiers <crescentbeachguitar@TELUS.NET>
Subject: Re: headlight relay installation problems...
Content-Type: text/plain; charset="iso-8859-1"
Wes, the wand IS the dimmer switch!
----- Original Message -----
From: "Wesley Pegden" <wes@CS.UCHICAGO.EDU>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Wednesday, November 23, 2005 5:09 PM
Subject: Re: headlight relay installation problems...
> Hi guys,
>
> I've fixed my problem. Indeed, the white wire was what I wanted. I was
> quite confused. Neither this, nor the yellow-and-black wire, go to the
> dimmer switch. Both run between the wand and the fuse box.
>
> -Wes
>
>
> Wesley Pegden wrote:
>
> > Hi guys,
> > I'm putting in relays for the headlights in my '84. I'm experiencing
> > some strange behavior, and am afraid I have shorted something out (but
> > maybe not, then again).
> >
> > To install the relays, I cut the low and high beam wires (on my '84,
> > these are yellow-and-black and white-and-black, if I've done this
> > right), between the headlight (dimmer) switch and the turn signal/high
> > beam wand to the left of the steering wheel. If I twist these wires
> > back together, everything works. If I hook them all up to the relays
> > (which I believe are correctly grounded and powered) then only the high
> > beams work (but they really work: i.e, they stay on, whereas with both
> > of these wires cut, the high beams will flash when you pull the wand,
> > but not stay). If I run just the high beam wires through one of the
> > relays, but twist the low-beam (yellow-and-black) wires together,
> > everything works, REGARDLESS of which relay the white-and-black wires
> > run through (Which is why I suspect the relays are okay). On the other
> > hand, in any configuration where the yellow-and-black wires go through a
> > relay, I can't get the low beams to work.
> >
> > Other possibly strange behavior: To get the low-beams to work, I need
> > to twist together both sets of wires, whereas for the high beams, just
> > twisting together the high-beam (white-and-black) wires is enough.
> >
> > Have I perhaps used the wrong wires? There's a white wire coming out
> > the signal wand... should I have used that instead of the
> > white-and-black wire?
> >
> > Thanks for any help, guys.
> >
> > -Wes
> >
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.362 / Virus Database: 267.13.7/180 - Release Date: 11/23/05
>
>
|