Folks, Been a long time since i posted to the list. This is a lengthy post. I have the van of a local fellow that has a problem. It is a late 80's 2.1 with digifant. It is an automatic.He has electrical problems. I offered to help him for there is no reliable place in our area to work on a vanagon. Here is what i know for sure. Newish battery. Has 13 volts. I personally cleaned all grounds, and mounted auxiliary ground from pin 19 of ecu harness to block. I even used copper anti seize on the bolt to ensure good connection. Fairly new rebuilt afm. He had replaced temp sensor II as well. Distributor was replaced with a rebuilt one in the past few years. Cap and rotor in good shape and are correct. Coil has been replaced in last year or so. I thought i had the problem nailed early on....the wrong spark plug wires were on the car..........early vanagon wires were on , not the later pin type connections. But i switched, and result s the same.
He admits to once reversing polarity on the battery for about 15 seconds once. This the wire from the starter to the alternator, which i replaced. Starter engages fine. Now here is what is bizarre. I hooked up digitool this AM. The car cranked right up. all lights on the digitool functioned and the car was running well. Then, suddenly, it died. I turned the key and it fired back up, the digitool showing this result. Then the car died, and would not start. While turning the key i would watch the digitool..occasionally the coil light and afm would flicker for a split second and the car would try to catch....but it couldn't the coil/fi lights did not stay on. I have 12v to the coil on the black wire. I have 12 v in the relay box the engine compartment as well. I have ruled out the ignition switch, for i have jumpered from the battery to the starter pin on the switch and then jumpered hot to the coil wires......same result...no coil light on the digitool. The wires are clean and well connected on the starter.......one wire comes off of the spade connector on the starter and goes somewhere in the engine bay.....I have wondered whether the starter solenoid is malfunctioning and not powering this wire.
I also noticed that when i leave the key on , and go in the engine bay, i can hear the relays clicking and i feel a vibration in the idle stabilizer unit......I unplugged it and turned the key, and the same result. I have unplugged O2 sensor as well, and same result. The car never runs long enough to get into the part of the ecu that uses the O2 sensor anyway. I am at wits end on this thing, for there is nothing that is obvious.
Adam P ))><(( Charleston,SC Coburn, WV "Mountaineers are always free" |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.