Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 2005, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 5 Dec 2005 08:41:32 -0500
Reply-To:     Christopher Gronski <gronski@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Christopher Gronski <gronski@GMAIL.COM>
Subject:      Re: Body & Fender Resource Needed
Comments: To: Doug F <vanagon@astound.net>
In-Reply-To:  <002201c5f954$72d75190$0202a8c0@noybcby07j8mkk>
Content-Type: text/plain; charset=ISO-8859-1

I missed the begining of this thread, but I'll add my $0.02 on my experience. My passenger side rear wheel well flare was damaged by an accident with a deer by the previous owner. It was pulled back into place but since developed seem rust between the upper pannel and the flare.

Therefore I would recomend replaceing the panel and the flare at the same time with one complete panel. Doug is correct they can be replaced serperatley but then you have to worry about that seam. Have a look at the panels available here, they are the one-piece pannel and flare and are only $16 more than the price of the arch alone:

http://www2.cip1.com/SearchResults.asp?Cat=602

Chris

On 12/4/05, Doug F <vanagon@astound.net> wrote: > The fender "flare" is actually a separate piece of metal that can be > replaced. > Many vanagons have the passenger side rolled in. > If you look there is a seam right above the flare that allows you to cut the > flare out of the body and replace it > When I last saw them they were running about $39 bucks each side. > > > ----- Original Message ----- > From: <JordanVw@AOL.COM> > To: <vanagon@GERRY.VANAGON.COM> > Sent: Sunday, December 04, 2005 2:09 PM > Subject: Re: Body & Fender Resource Needed > > > > In a message dated 12/4/05 4:02:18 PM Eastern Standard Time, > > samc@SURFGLOBAL.NET writes: > > > > > > > I'm not interested in paying for two future generations of someone > else's > > > family, but I need a competent, "fair-cost" body and fender service > within > > > 30-50 miles of Burlington, Vermont. The 84 Westphalia is showing its > age. > > > SamC > > > > > > > i wasnt aware vanagons had fenders... :<) jk! ... anyway, try > > John's Car corner in Westminster....im sure w/ 25+ years of working on > vw's they > > have some leads on a good bodyshop for your West*F*alia :<) > > > > chris >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.