In a message dated 12/12/05 1:31:56 PM Eastern Standard Time, albeeee@MCHSI.COM writes:
> Are you suggesting that I get these STEEL wheels machined out in the > center? I realize one can machine steel, and since they are not hub > centered on the Vanagon, the job doesn't even need to be particularly > accurate. > you said audi rims, i assumed they were alloys. but yes you can machine the centers...steel or alloy, doesnt matter. since theyre steelies, then you dont have to change your rear studs. whats the offset stamped on the wheels?? i know the audi 5000T/200 alloys were 45mm, im not sure of the steels.. chris , who has run a number of different audi wheels on vanagons before.... |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.