It would be a gross mistake to try it yourself. The holes need to be 100% accurate. If even one is slightly out it will stress the studs, possibly leading to breakage. If all are out (which is a 99.999% probability) the wheel will be off-center and will cause vibration. And the wheel will be ruined. I had a set of 18" wheels machined. It cost me $50NZ... around $35US. Why mess around? -- Andrew Grebneff Dunedin New Zealand Fossil preparator <andrew.grebneff@stonebow.otago.ac.nz> Seashell, Macintosh, VW/Toyota van nut HUMANITY: THE ULTIMATE VON NEUMANN MACHINE DEMOCRACY: RULE BY THE LOWEST COMMON DENOMINATOR |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.