Date:         Sat, 31 Dec 2005 12:33:18 -0700
Reply-To:     Karl Wolz <wolzphoto@WORLDNET.ATT.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Karl Wolz <wolzphoto@WORLDNET.ATT.NET>
Subject:      Re: T-Pipe at the gas intake
Comments: To: Michael Edwards <medwards1@TRIAD.RR.COM>
In-Reply-To:  <001f01c60dfd$c9876b20$6401a8c0@michael1>
Content-Type: text/plain; charset="us-ascii"

Couple times I've dropped the tank I've used closed cell foam and an old
bicycle inner tube (no glue).

Karl Wolz

> -----Original Message-----
> From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On
Behalf Of
> Michael Edwards
> Sent: Saturday, December 31, 2005 4:32 AM
> To: vanagon@GERRY.VANAGON.COM
> Subject: T-Pipe at the gas intake
>
> I too am starting on this project, and am also waiting on the
cross-over pipe.  I want
> to have all the parts ready and on hand before I drop the tank.
> One thing I can't seem to find are the rubber buffers on the two
supports that go
> under the tank.  ETKA did not seem to show these as separate parts
from the
> support brakets.  My supports are pretty rough so I want to powdercoat
them and
> will need to replace these two buffers.  Does anyone know if these are
available
> independent of the brackets?  I guess you could always glue on any
piece of
> rubber, but would prefer the original that attaches through the
bracket.
> Thanks,
> Mike