Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2006, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 12 Jan 2006 21:15:16 -0500
Reply-To:     Dennis Haynes <dhaynes@OPTONLINE.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <dhaynes@OPTONLINE.NET>
Subject:      Re: interference engines.....was Re: How much would this cost
Comments: To: Zoran Mladen <zmaninco@yahoo.com>
In-Reply-To:  <20060113020220.31678.qmail@web33515.mail.mud.yahoo.com>
Content-Type: text/plain; charset=us-ascii

All I tried to say was that teeth shearing was more a failure mode than actual breakage.

Dennis

-----Original Message----- From: Zoran Mladen [mailto:zmaninco@yahoo.com] Sent: Thursday, January 12, 2006 9:02 PM To: Dennis Haynes; vanagon@GERRY.VANAGON.COM Subject: Re: interference engines.....was Re: How much would this cost

I beg to differ on the 2.0 liter engine...it IS an interference engine. I have seen the timing belts break and the havoc they leave. The valves will be bent.

Z

Dennis Haynes <dhaynes@OPTONLINE.NET> wrote: Actually, on the 8 valve engines, the timing belts rarely break. Usually they get loose due to the lack of a compensating Tensioner, and then at the most inopportune time, 2 or 3 teeth will shear off they go around the crank sprocket allowing the crank to continue turning with moving the belt.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Tim Demarest Sent: Monday, January 09, 2006 12:03 PM To: vanagon@GERRY.VANAGON.COM Subject: NVC: Re: interference engines.....was Re: How much would this cost

Thanks Chris, but now you've done it... given me an excuse to put the job off longer. Maybe I should at least move that belt from the shelf to the trunk of the Jetta, so I have it with me when I get stuck by the side of the road... :-)

btw - it's the 2.0, I was waaaay too cheep to spring for the extra $4K to drive away from the showroom with with a VR6,

tim.. '97 jettas wont bend valves if you break the TB. the only engine >offered in '97 on the mk3's was the 2.0 8v or the Vr6, neither of which is an >interference engine... i think the TDI is an interference engine, though... > >chris

_____

Yahoo! Photos Got holiday prints? See <http://us.rd.yahoo.com/mail_us/taglines/holidayprints/*http:/pa.yahoo.c om/*http:/us.rd.yahoo.com/mail_us/taglines/photos/evt=38089/*http:/pg.ph otos.yahoo.com/ph/print_splash> all the ways to get quality prints in your hands ASAP.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.