New lifters or used? Zero clearance seem s to be a good place to start. Bob Donalds has a great page on the subject either way. http://www.bostonengine.com/articles/hydraulicll.htm On 1/26/06, Matthew <mpteleski@yahoo.com> wrote: > > folks, > trying to get the lifters to pump up after a head job. > It will barely run b/c i can't get the valves set > right when the lifters ain't solid. this bus sat for 5 > years before doing the head job. any advice? just run > it till it is warm and then adjust? > thanks > matthew > > __________________________________________________ > Do You Yahoo!? > Tired of spam? Yahoo! Mail has the best spam protection around > http://mail.yahoo.com >
-- Jake 1984 Vanagon GL 1986 Westy Weekender "Dixie" www.crescentbeachguitar.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.