If you remove/loosen up some perferal appendages around the engine compartment,and remove the 4 bolts that hold the engine carrier to the frame,can you drop the engine/trans assembely a few inches to get clearence to use a drill? May have to take the exhaust off at the j pipe to the tail pipe in one section. Just wondering, as I thought of doing this to replace a main seal without removing the engine.Could stick in a new oil pump at the same time, I think.Good luck.Sorry to hear about the bracket snafu.It seems marginal in stregnth to begin with. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.