Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2006, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 9 Feb 2006 16:50:23 -0800
Reply-To:     Zoltan <zolo@FOXINTERNET.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Zoltan <zolo@FOXINTERNET.NET>
Subject:      Re: Windshield Leaks
Comments: To: John Rodgers <inua@CHARTER.NET>
Content-type: text/plain; format=flowed; charset=iso-8859-1; reply-type=response

The only way I know to fix that is to calk clear calk under the edge of the rubber. Just cut the calk nose at the very end to have less than 1/8th thick bead, push that nose under the edge and pull it around, holding it at the nose, while you push the calk. Don't worry about the excess. That you will take off after the calk dried. But try to blow out water from under the rubber before you do this. You don't want to trap water in there perhaps. Zoltan ----- Original Message ----- From: "John Rodgers" <inua@CHARTER.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Wednesday, February 08, 2006 8:46 PM Subject: Windshield Leaks

> New Windshield, new no-trim seal, shop install, and it leaks in the > corners everytiime it rains. > > I have been assured it is a proper installation, "roped" into place, > surfaces for the new seal thoroughly cleaned, no "sealer" used as it was > not necessary. So if it is a proper installation, what is causing the > leaking at "both" corners. Everytime it rains water, drips down on the > carpet just under the dash. Doesn't just pour in, but does wet the carpet. > > I'm a bit exasparated with this. It is evident that the shop feels that > they have done it right and there really isn't any way to actually > improve on the mechanics ot the installation. So I think I am going to > have to come up with the way to get that accomplished and impart it to > them. They are willing enough to take it on. > > Any Bentley procedures calling for anything special that I should know > about?? > > Any suggestions on how to deal with this would be appreciated. > > Thanks, > > Regards, > > John Rodgers > 88 GL Driver > > > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.1.375 / Virus Database: 267.15.2/253 - Release Date: > 2006.02.07. > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.