My interpretation of the whole thing (I'm dealing with similar issues) is that the O2 sensor works, no matter what temperature it's at, but the ECU is programmed not to pay any attention to the voltage it produces until the Temp II sensor says the engine is warm enough. Before that time, the O2 sensor produces voltage, but it's erratic. I installed one of Ken Lewis' O2 sensor volt meters on my instrument panel to have a constant monitor, and it's truly eye-opening to see what's going on. When the engine's running rough and has no power, sure enough, the oxysensor is putting out low voltage, indicating a lean condition. If I were to replace the one-wire oxysensor system, it would be with a four-wire, not three, because I think the ground needs to be absolutely certain for these to work, and the old tailpipe structure seems a poor ground at best. I grounded my O2 sensor with a wire and a radiator hose clamp. The engine will run ok without the O2 sensor, but you'll spend a lot on gas... |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.