Should I clean up and repack the other while I'm at it? (and replace that boot as well). Am I correct in assuming taht doing both isn't much harder than doing one? -Wes John Rodgers wrote: > Wes, > > A tear in a boot is a guarantee you have sand and grit in the bearing. > Not much to do but take it apart, clean it, inspect for wear and > pitting. If the bearing is good, re-grease, install new boot, then > re-install. > > Good Luck, > > Regards, > > John Rodgers > 88 GL Driver > > Wesley Pegden wrote: > >> So... >> I was changing my rear shocks, and I noticed my driver side rear cv >> joint has a tear. What should I do about this? Is there a way of >> checking whether the joint is okay without removing everything? And is >> changing just the boot easier than changing the whole bearing? >> >> Thanks for any tips... >> >> -Wes >> >> > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.