In a message dated 2/24/06 2:04:17 PM Eastern Standard Time, inua@CHARTER.NET writes:
> Subject says it all. > > I must replace my levers. but how the heck do you do that?? I have new > ones, but I'm mystified as to how to get to them for r&r. > > Any suggestions will be appreciated. > > i use needlenose pliers... be CAREFUL not to catch the part of the lever that slides over the metal tab on the climate control faceplate - otherwise you'll crack the faceplate too.. i usually use a thin flathead to hold it down while im pulling w/ the needlenose pliers... BTW - use alittle grease on the metal tabs before you put the new ones on...so they'll be easier to remove next time.. chris |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.