I am almost finished with my boxer to inline conversion and I had the transmission rebuilt with diesel bell housing. I have the clutch slave cylinder mounting bracket from the boxer bell housing mounted on the diesel bell housing and the slave cylinder is contacting the level arm correctly but the mounting flange is about ¾” above the bracket. Is the bracket from the diesel different? I looked on the Bus Depot site and the cylinder appears to be the same for all Vanagons.
Thanks for the help,
John Stepto
Engineering Manager
KV Pneumatics, Inc.
1140 McDermott Drive
Suite 104
West Chester, PA 19380
(610) 946-9000 fax (610) 946-9001
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.