Quick question and short story: Fridge remove, cleaned, tested in any way i can, combustion chamber cleaned and re-seal, fan work great, new propane tank, good flow to fridge, but after????. Result: Light up/start up fine the first time without "priming" on 110V, good flame in the windows, good heat in exhaust, stable flame.... but, it dosn't fleeze much???? (temp around 45-55F) The thermostat as not much effect on it except when at the 0 position, it goes in the pilot mode I'm not sure if the flame is stong enough???? or a leak in the exhaust will cause that. Fridge works fine on 110V (40-44F), any suggestion??? this fridge in question didn't work for years, but is close to freezing point on 110V and on 12V. Any suggestions? |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.