Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2006, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 17 Mar 2006 18:32:03 -0800
Reply-To:     Doug F <vanagon@ASTOUND.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Doug F <vanagon@ASTOUND.NET>
Subject:      Re: Propane lines
Comments: To: Jeffrey Vickers <jeff@VICKERSDESIGN.COM>
Content-Type: text/plain; charset="iso-8859-1"

When I did my syncro gl to westy conversion, one of the objectives was to be able to remove the entire stove,fridge,sink unit easily and keep it in the garage. Allowing me to still use my van as a cargo van most of the time.

I found some very high quality reinforced rubber fuel line at Ace Hardware that is 5/16 or so and has a 200 psi fuel rating. I converted the stove and fridge both over to 5/16 barbed brass fittings and joined them to a single line and then out the bottom of the van to a quick connect bbq coupling near the regulator. I made sure to use a thick rubber grommet where the hose passes through the floor. I decided to use the rubber fuel line and hose barbs after several attempts at getting exact flared ends to offer a 100% seal. With the rubber hose it is absolutely no leak and a good tight fit. I use 2 nylon zipp ties in place of metal clamps on each barb Never had a leak and very easy to deal with compared to copper. It is my intention to just change them out every 5-7 years One of the things you may not realize is that the pressure on the lines after the regulator is only 1psi and you can block it at the end of the hose with the tip of your finger quite easily. Using 200 psi lines and barbed fittings is plenty to seal up 1 psi.

Copper lines can rub and wear through too and can kink and leak and are tough to deal with.

Doug

----- Original Message ----- From: "Jeffrey Vickers" <jeff@VICKERSDESIGN.COM> To: <vanagon@GERRY.VANAGON.COM> Sent: Friday, March 17, 2006 1:45 PM Subject: Propane lines

> I want to replace my propane lines now that I have my fridge cabinet > out---they're a little tweaked---is it possible to use some sort of > flexible propane lines instead of the copper tubing? Flexible hosing > would be easier than new lines if its safe to use such a thing. Thanks. > > > Jeff > > 87 Syncro Westy


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.