Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2006, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 17 Mar 2006 23:00:43 -0600
Reply-To:     John Rodgers <inua@CHARTER.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         John Rodgers <inua@CHARTER.NET>
Subject:      Re: Done: Re: (rear) cv joint
Comments: To: Wesley Pegden <wes@CS.UCHICAGO.EDU>
In-Reply-To:  <4416F92F.7070602@cs.uchicago.edu>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Hey Wes!!

Don't you feel a sense of accomplishment, sattisfaction and security( as much as can be had with a Vanagon), now that you have been through it personally?? No more mysteries and unknowns, which sprouts fears of getting stuck somewhere in the middle of nowhere?? I know I sure felt that way.

Just remember to repack them in 25,000 miles. Do it every time and those CV's will last forever. Inspect regularly for toorn boots, though. A torn boot will trash a CV in short order. You can re-pack with a needle point grease gun by getting the needle up under the shaft side of the boot and squirting the grease in there. Then milk the boot around to get the grease where it needs to go. I would not do it but every other time though. The do need to be disassembled, cleaned and inspected, and regreased at about 50,000 mile intervals. But fresh grease every 25,000 is key.

Glad to hear you are on the road again.

Regards,

John Rodgers 88 GL Driver x2

Wesley Pegden wrote:

> CV joints are DONE (last night). Thanks to everybody who helped out. > I'm glad to be back on the road again. > > -Wes > > > Wesley Pegden wrote: > >> Okay, one more thing: >> How do people get the new boots on the axle shafts? It's harder than I >> thought. I'm sure I can get them on, but I'm a little worried about >> damaging the boots in the process.... >> -Wes >> >> Wesley Pegden wrote: >> >>> Can anybody tell me what the holes in either end of the axles are for? >>> Should I put grease in them before reinstalling? >>> >>> Thanks, >>> Wes >>> >>> Roger Sisler wrote: >>> >>>> Put two zip ties through each axel to imobilize the joint.If one ball >>>> falls >>>> out(very very ez to do), the others will think it is ok ot come out, >>>> and >>>> they will.Talk about messes. >>>> >>>> >>> >> > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.