The centering tool is the least of your problems. There are several other detail that you should not over look. I need to rebuild a clutch myself. Its chattered all its life. Flywheel is being cut as you read this, (thanks Walt). The last years, it has been dragging. I'm replacing the engine soon, and I need a pilot bearing and its seal, and a kit to rebuild the throw out bearing shaft. Any sources for this as a complete kit? These parts are critical to make the clutch work smooth. Hey Boston Bob. What do you use for those pilot bearing seals.? Joe W.
Jens Jakob Andersen wrote: > Hi, > > If I go for changing the clutch myslef, I have 2 questions: > > 1. Can I do it with the engine in the Van? > 2. Can I make a DIY clutch centering tool? > > /JJ > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.