Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2006, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 26 Mar 2006 08:30:10 -0700
Reply-To:     Richard A Jones <jones@COLORADO.EDU>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Richard A Jones <jones@COLORADO.EDU>
Subject:      Re: running hot....ideas?
Comments: To: JordanVw@AOL.COM
In-Reply-To:  <20060326140913.C326882078@mx11.Colorado.EDU>
Content-Type: text/plain; charset=windows-1252

With the discussions on thermostats, here is an interesting bit from Ben Huot's webpages: http://www.benplace.com/front_radiator.htm

> VW is now at the letter “F” (part # generation) for > the standard 87deg thermostat, but I called VW Canada > yesterday and they explained to me that the “F” thermostat > was a bit higher than 87 deg and the older model were a > bit lower than 87deg!!!!!!, they say that the van was > running too cold with the subsequent model (A to E!!!!!). ....................... > Also, VW confirmed that the new thermostat and the > new temp gauge sensor (the one in front of the thermostat > housing) give a higher reading (for the sensor, about 15% > more) and higher temperature (for the thermostat, about > 20% more heat). The gauge should normally (by VW spec) > read ¾ or a bit below that. > > I find it completely stupid that the gauge is not > in the middle when at normal temperature, it is logical > to have the same proportion each side of the needle for > an accurate reading and safety (more time to stop the car > in case of overheating). My little Honda gauge is always > in the middle like it’s frozen there, I once had an > overheating problem due to a lost of pressure and in > went all the way near the red section giving me some > time to stop the car. > > Note: the VW car (not van) I worked on had a 3/4 reading > in the front at normal operating temperature. I just changed > my thermostat and sensor and I had the 3/4 reading in the > front, I didn’t like that at all and went back with the old > one. I like to see my needle in the middle, period.

Richard A Jones Boulder, Colorado


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.