Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2006, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 18 Apr 2006 07:34:21 -0500
Reply-To:     Larry Alofs <lalofs@RCN.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Larry Alofs <lalofs@RCN.COM>
Subject:      Re: Which O2 sensor?
Comments: To: Jeffrey Vickers <jeff@VICKERSDESIGN.COM>
Content-Type: text/plain; charset=us-ascii; format=flowed

It's hard to get accurate measurements with a typical meter because the voltage changes rapidly (if the sensor is working right). An old fashioned analog meter with a needle responds faster, but uses too much current and would wipe out the signal you're trying to measure. With a digital meter of reasonable quality you should be able to get an idea of what's going on: Connect the negative (black) meter lead to a good ground point. Connect the other lead to the place where the O2 sensor wire connects to the wiring harness, with the sensor connected. With the engine idling, the voltage should change continually in the range between 0 and 1 volt, if the sensor and ECU system is working. Most of the readings will be inaccurate because the meter is not able to update fast enough with the voltage going up and down once a second or so in a working system. It should go back and forth from near zero to near 1 volt; the more times it crosses half a volt the better. If the voltage stays steady enough that you can get a solid reading the sensor is probably bad. If the voltage stays less than half a volt the sensor is weak or the ECU and fuel system is not capable of producing a rich mixture for some reason. When our Golf had a bad sensor, the voltage would stay low most of the time and then slowly move upward once in a while and then drop down again. If you can search the archives for posts by Mark Keller (sp?), you may find more useful info on this topic.

Hope this helps, Larry A.

Jeffrey Vickers wrote:

> No. I just assumed that since I unplugged it and the stumbling went > away that that was the problem. I have a little digital multimeter, > though. How do I do the check? > > Thanks, > Jeff > On Apr 17, 2006, at 2:55 PM, Larry Alofs wrote: > >> Have you checked the sensor with a meter to be sure that it is weak? >> >> Larry A. >> >> >> Jeffrey Vickers wrote: >> >>> I've been getting stumbling/missing between 3 and 4K rpm so I >>> disconnected my O2 sensor and it seems to have cured the problem. >>> What's the consensus on a new sensor? Bite the bullet and go with and >>> OEM unit or get the generic and splice in the plug? >>> >>> Jeff >>> 87 Syncro Westy >>> >> >> >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.