Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2006, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 30 Apr 2006 17:10:46 -0700
Reply-To:     TC <trclark@SHAW.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         TC <trclark@SHAW.CA>
Subject:      Curious location change of water, electric vents 85 to 86
Content-type: text/plain; charset=iso-8859-1

So I will weld in the new driver side rocker panel & new metal on the rusted out applicance panel on my 85 westy this week ... but I have not decided where to cut in the electric, & water inlet s I am thinking I might cut them in like the 86 and later models where the electric for shore power is up high like the water inlets

was this change made because being down low the inlet was subject to more road wash and thus more likely to rust ?


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.