Hi Shawn. A bigger hammer? ;) I've never done this particular job before but..... As the drive shaft should be allowed to move in vice, make sure cv assembly is not "bouncing" around on vice jaws when driving shaft down/out. i.e. it stays in place when you are tapping. Solid impact/contact is crucial when drifting things out. And.... Don't know if it's wise, but maybe a helper could, from below, pull down on driveshaft when you are tapping from above. I'm sure others will correct me if that's a dangerous idea..... ;)
Neil.
--- Shawn Wright <swright@ZUIKO.SLS.BC.CA> wrote: > After just re-installing my axles, I find one of the > old boots (I replaced two of > four) has a small hole allowing little blobs of > grease out. This was one of the > CVs I could not get off the shaft, so I put it back > on. I suppose I could pull > the *other* CV and install the boot from the other > end, but I'd rather figure > out how to get the stuck CVs off. I have removed the > circlip and tried tapping > the end of the shaft with a cold chisel while the > outer joint was supported in > a vise, but it would't budge. Both my inboard CVs > are now stuck like this, > and will wear out eventually... > Any ideas appreciated. > > > Shawn Wright > http://members.shaw.ca/vwdiesels > '88 Westy 1.6TD 5 speed > '85 Jetta Diesel 1.6NA >
Neil Nicholson. 1981 air cooled Westfalia. Cheap-o web site: http://www.members.shaw.ca/tubanick/welcomewesty.html __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.