Er, nothing "wrong" with plumber's solder, per se, I suppose, so long as it's not from an old roll in your grandfather's tool box. If so, it likely contains lead, which if overly ingested in food, water or air particles can turn your brain to mush, over time. Other than that it MIGHT BE fine. Lots of the solder on the market today contains antimony instead of lead. Which may mean that instead of merely turning to mush, your brain may merely turn orange with green stripes and canary yellow polka dots in a few years, instead. Most copper bowl, cups, turns (sp?) and other items of traditional copperware for the dining table, such as made by Paul Revere, etc., usually had silver solder so that the items could contain piping hot foods without fear of a low temperature solder melting into the soup. One consideration might be that if you are traveling somewhere where road temperature can top 120 degree F, and your unit is secured under the floor of the vehicle, that radient road heat might cause leakage, if the melting temperature of the solder is less than the temperature of the road. This is America and can you solder with any dang temperature solder you decide is best for your purpose and needs. Dave davidgunning@pivot.net .
Most modern plumbing solder is "lead free", these days ----- Original Message ----- From: "Larry Alofs" <lalofs@rcn.com> To: "David Gunning" <davidgunning@PIVOT.NET> Sent: Monday, May 22, 2006 4:47 PM Subject: Re: [VANAGON] Under Floor Water Tank Still Needed
> > > David Gunning wrote: > >>> >>> Of course, if it was me, I would probably head over to Home Depot for a >>> few hanks of copper sheet flashing and try to build a unit to custom >>> specs. The trick with doing it that way, however, if there is one, >>> would >>> be to absolutely use REAL silver solder, not that fake plumbers silver >>> solder stuff. The only difference in soldering real silver solder is >>> that >>> the actual soldering temperature needs to be alot higher to get it to >>> flow >>> properly, requiring oxygen to boost the acetiline or propane soldering >>> torch temperature hot enough. >>> >>> Dave >>> > So, if it holds, what's wrong with plumber's solder? > > Larry A. > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.