Date: Wed, 14 Jun 2006 17:39:20 -0700
Reply-To: Shawn Wright <swright@ZUIKO.SLS.BC.CA>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Shawn Wright <swright@ZUIKO.SLS.BC.CA>
Subject: Re: CV axel disaster
In-Reply-To: <20060614211424.53811.qmail@web60215.mail.yahoo.com>
Content-type: text/plain; charset=US-ASCII
I take it this is a stock Diesel Vanagon, since you mentioned 55mph... I'm
guessing those were cheap aftermarket CV bolts, if a 1.6NA managed to
shear them off! I've stalled out my 2.1L plenty of times in rough terrain and
never broke anything. If you replaced the bolts, it would be good to know
where you got them...
On 14 Jun 2006 at 14:14, roger sisler <rogersisler2000@YAHOO.COM> wrote:
> What is the worst thing that can happen with a CV axel? Well ,it almost
> happened to me. I drove 75 miles on sunday morning to fetch my new old 81 parts
> van, diesel vanagon. 75 miles on open highway, at my blistering 55mph(honest).
>
> When I arrived at the location of the vanagon,there was a 1/4 mile long rutted
> dirt drive way. I creaped along and when I was exactly where I wanted to
> go.(the vanagon diesel ) ,I kinda got stuckin a rut. I stalled out in first
> gear and heard a "ping". I put it in first,second,third fourth,reverse.
> Nothing. I thought I blew my trans(gowesty says Im due for it).This van would
> not move. Funny, I thought the third-fourth slider thing was the common
> ailment. It is supposed to get stuck in a gear. I was stuck in neutral. I got
> out and manuaklly clicked the lever into a gear. Still nothin. Well, I pushed
> it off the road and looked again. The CV axel was hanging down from where it
> was suppposed to be on the transmission drive flange. Imagin going ay 56mph
> and having the axle falloff gthe drive flange. A totaled vanagon and all other
> cars near by. I had checked it a month ago, and it was fine. New grease was
> splattered only recently ont eh trans/starter/shifter area. It is like
> it loosened up almost all at once. Upon closer inspection, I found that the 6
> bolts that hold the axel to the trans had been completely sheared off. All
> 6.The threads were left inside the drive flange, and the shanks with the joint.
> All 6. All 6 shanks remained in the joint. You'd think that if this had
> happened over time, a shank or two would have been thrown off. Not so .I got
> all6 at home. Turns out that I had a new flange on the parts vanagon ,only 100
> feet away. It was an old style 091 trans, where my 85 has a 091/1 trans. The
> drive flanges are different it turns out. By a few thousnads of an inch, the
> circlip wont fit.Gotta use the thinner 091 circlip with the4 091 flange. the
> 091/1 circlip with the 091/1 drive flange. What do you think?
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam? Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
>
Shawn Wright
http://members.shaw.ca/vwdiesels
'88 Westy 1.6TD 5 speed
'85 Jetta Diesel 1.6NA
|