How about zip ties!?!?!?! Speaking of which...right tool for right job... A co-worker of mine, ex military so he knew better, had a lapse in judgment and used a hunting knife to cut a nagging zip tie...well, it didn't cut the zip tie but slashed his arm. He has lost a lot of use of the hand and is in therapy... I know how tempting it is to just grab anything because its available...especially when you are like 8 hours into a "half hour" project... PLEASE!!! Always use the right tool (or be as reasonable safteywise as you can) for the job!!! Dave On 6/13/06, bueses <bueses@earthlink.net> wrote: > > What no duct tape, bailing wire, or JB weld? > > Tom-always the right tool for the job? > > > > on 6/12/06 8:08 PM, Jim Felder at felder@KNOLOGY.NET wrote: > > > All this goes in the plastic case, which is about the size of a three- > > ring binder. I have done pretty major work to both cars by reaching > > for no more than one of these kits. >
-- Dave - KC9FYM http://fjazzbass.blogspot.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.