In a message dated 6/13/06 3:13:33 AM Eastern Daylight Time, syncro@GMAIL.COM writes:
> I managed to cut some front wheel arches to be used to replace my badly > damaged existing arches. After that long struggle today with the Sawzall. I > was rewarded with nice replacements. Trouble is I can't tell how they are > attached to the bodywork. It almost looks as if they are glued on. Before I > spend another afternoon peeling paint to look for spot welds, I thought > about asking some of you who may have dealt with this before. I know now is > they are welded at the rear corners the doorjamb. I know how to cut those > out to free them up. The bottom is thick with undercoating i have cut them off before, but have not gone as far as removing the arch section from the factory spotwelds on the body section... the spotwelds are hidden well under some serious factory seam sealer.. best thing i can say is just take your time use the heatgun to remove the seam sealer and identify the spotweld locations.. chris |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.