In a message dated 6/12/06 10:04:28 PM Eastern Daylight Time, macdonald1987@SBCGLOBAL.NET writes:
> The worst thing there is to do is to "invent" new anchors for the bottom > mounts on the rear-facing seats. Large Allen bolts, with their large openings, > promise to be the most secure. Just select the size that fits the posts on > the bottom of the seat, and tighten into new holes in the floor, with a washer > and a nut. That should be at least as secure as the buttons welded onto the > floor for the original mounts very good suggestion.... alot easier than welding in the factory jumpseat foot "cups" to the floor.. chris |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.