On 6/20/06, Florian Speier <groups.florian@gmail.com> wrote: > > Hi group, > > I recently bought and installed a sports steering wheel in the westy. I > bought it as a complete kit on german ebay from a seller who assembles > kits > for vanagons in a way they are german tuv approved (the blinkers stop > automatically). > installation would have been a bliss if in the detailed info one would not > have been required to take off the aluminum casting that holds the key > lock > and the plastic washer piece underneath and put an addtl spring on the > steering column underneath it, to "make it safe". thenn i screwed the > wheel > back on. > Now I just dont know if the upper and lower steering column still > interlock > enough to be safe or if they might be able to pop out if the spring > compresses more? or something. how much should they interlock, and has > anyone else experience with this mod when adding an aftermarket steering > wheel? > > I experimented with a VW steering wheel (off a Jetta I believe) that had what I think was the same issue as your aftermarket steering wheel. The Vanagon wheel has the splined socket deeper in the wheel than usual, so when a wheel designed for "regular" VWs is installed it sits too high and neither the horn contact nor the turn signal cancellation tab can "reach". The steering column can be pushed down so the wheel comes in contact, but I found this caused the column to rattle loosly in the upper housing somewhere. I assume you have a wheel originally designed for "shallow socket" VWs and the additional spring is a fix to let you shorten the Vanagon steering column without it being "loose". As far as sliding the steering column down, you probably still have plenty of contact at the intelocking flange near the floor. You may need to remove the plastic housing from the steering column to see it, but you should inspect the interlocking flange thing down near the floor, if for no other reason than peace of mind. Given that once the steering wheel is fastened on the shaft cannot be pushed father down, if the two pins extending through the holes in the flange aren't about to fall out, you should be fine. As I recall they have quite a bit of "extra" length to them, so they're probably good. -- John Bange '90 Vanagon - "Geldsauger" |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.