Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2006, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 18 Jun 2006 10:59:27 -0700
Reply-To:     Jake de Villiers <crescentbeachguitar@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jake de Villiers <crescentbeachguitar@GMAIL.COM>
Subject:      Re: leak at trans or rear main Question to pull
Comments: To: Jonce Fancher <streetbugs@whispllc.com>
In-Reply-To:  <vanagon%2006061812563331@GERRY.VANAGON.COM>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Well Jonce, I don't know what's leaking from your Vanagon, but you don't have to go through all the hassle of dropping the motor to replace the rear seal. Just drop the transaxle back and down; there's a lot of movement in those CV joints!

When you sniff the leaks, are they gear oil or engine oil?

Jake

On 6/18/06, Jonce Fancher <streetbugs@whispllc.com> wrote: > > Hi all > Well my shake down camp trip went well the motor is running like a top. > > But I drove a 35 mile each way trip without a drop of anything. when i > pulled into the drivway shut it down and pulled the bikes of the racks to > put the camper in > the garage. So it sat for about 10-15 min. From there i backed it up the > drive and into the garage and we proceeded to unload from the weekend trip. > I left it just > hang out the front of the garage to get the back hatch open and once the > rear was unloaded i pushed the rest of the way in. After it sat for about a > half hour i > do my look under to see if any leaks. i found 1 more forward and two from > just under the seam between the engine and trans. So i wandered out to look > at the > drivway and found Nothing at all on the driveway. So i guess my question > is could the trans be to full?? or to warm and just drop a few?? the motor > is good on oil > and between the 2 marks. Would or Do i need to pull the motor to inspect > and or check out?? The rear main was replaced and Im positive i swapped out > the > input shaft seal as well. So why or where could it be leaking?? Ive got 3 > weeks till drive time and i really didnt want to pull the motor again for > this. > > my plans are to check trans fluid (its a 4 speed manual) so 90W. recheck > lugs and rear hubs to make sure everything is tight. Double check the spare > tire. and > of course get spares to take with just in case. but if i need to pull the > motor i need to get hoppin. Thanks Jonce > > Jonce Fancher > > 56 Single Cab > 66 Sunroof Bug > 66 Variant Squareback > 66 Porsche 912 > 71 Sunroof Bus > 84 Vanagon "Gottfried" > 85 Vanagon Westi > 2003 10 Passenger Sprinter > > Fancher's Upholstery Inc. - www.fanchers.com > Not-A-VW Club- http://mywebpages.comcast.net/jaransont3/notavwclub/ >

-- Jake 1984 Vanagon GL 1986 Westy Weekender "Dixie" www.crescentbeachguitar.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.