Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2006, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 14 Jun 2006 22:02:51 -0700
Reply-To:     Mike Miller <mwmiller@CWNET.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mike Miller <mwmiller@CWNET.COM>
Subject:      Re: Headlight / turn signal problems
Comments: To: "Mcallister, Kevin R." <kmcallis@WATER.CA.GOV>
In-Reply-To:  <30CA44F956F0E545825A119B6FE2DD0C02AB1BF9@sacex3.ad.water.ca.gov>
Content-type: text/plain; charset="US-ASCII"

Can't say about the turn signals but my headlight problem was identical. I had a bad connect to the female spade connector on the grounding terminal under the dash. Tested good I think because when I put the probe on it the pressure made the connection. Pressure off, bad connection.

Mike

On 6/14/06 9:39 PM, "Mcallister, Kevin R." <kmcallis@WATER.CA.GOV> wrote:

> I've tried searching on the archives but never have much luck so here > goes... I'm trying to solve a headlight/turn signal mystery on my 87 > westy. When the low beams are on, the passenger side appears somewhat > "yellow" while the drivers side burns fine. When I switch on the > highbeams, the drivers side is normal but the passenger side high beam > does not come on at all and the high inside the low beam bulb just gets > even "yellower". Add to this a turn signal problem that may be > related?: my left turn signal blinks fast, right normal, but right will > not blink at all when lights are on (park or headlights) and the left > bulb has both filaments burning (turn and indicator) when lights are on. > So far I've changed out all of the turn signal bulbs, one badly corroded > socket, all of the headlight bulbs, headlight switch, and added > headlight relays. No change in either condition. I also dropped the > fuse panel and cleaned every ground on the two star grounds, cleaned > behind them to bare metal, and replaced any connectors that were > corroded, still no change. I'm going to try a new turn signal switch > next but I'm getting tired of buying parts. Looking for any other > suggestions from those that have walked before me, thanks. > > > > Kevin > > > > 87 westy, "Wes the trip ship" > > > > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.