Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2006, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 28 Jun 2006 10:20:32 -0400
Reply-To:     robert shawn feller <carboncow@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         robert shawn feller <carboncow@GMAIL.COM>
Subject:      Re: Coolant pipes replacement
In-Reply-To:  <44A28A3A.3020807@verizon.net>
Content-Type: text/plain; charset=UTF-8; format=flowed

The marine hoses in question are far more thick then the orignal plastic so they most likly have some insulating effect but I doubt it is of concern is effecting the cooling efficency of the system.

The metal (and original plastic) hoses acting as a heat disipater is just a theory until someone has done the testing and I'm not completely sure I agree with that theory. I would consider the marine grade hoses combined with the lower fan thermo-switch from BD, thus you fan is kicking on sooner if you feel you are loosing a few degrees of cooling effect from the long run. But as others have stated there is an ideal operating temp for the engine, until you can prove the very thick marine hoses are increasing temps...just stay with the stock switch in average climates. I personally would do the marine hoses.

Shawn

On 6/28/06, Mike Collum <collum@verizon.net> wrote: > Personally, I can't see that insulating those pipes would be detrimental > to keeping the engine at the proper operating temperature. > > In northern climes, insulating the fore and aft heater hoses has a > positive effect on the heater output, though. > > Mike > > > mark drillock wrote: > > The first 5 years had metal pipes, the next 20 years or so had plastic, > > even as the engines became more powerful. Clearly VW did not consider > > metal pipes to be the way to go. > > > > Mark > > > > Kenneth Lewis wrote: > > > >> I have to agree with Richard on this one. First, the Digifant series > >> has plastic tubes which would be comparable, in heat loss, to rubber > >> hoses. > >> Second, even if you lost some cooling effect from the tubes, this > >> radiator > >> is used to satisfactorily cool much larger engine transplants, so it has > >> plenty of extra capacity . > >> Ken Lewis > >> http://neksiwel.20m.com/ > >> > >> > > >

-- shawn feller, ohio 1986 vw vanagon gl westfalia 1993 vw eurovan gl plus a couple of saabs, boats, jet skis, dog and wife (all require to much maintenance, accept the dog)...

www.carboncow.com www.carboncow.net


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.