To check your fan at the front of the van,first remove the lower grill. Pull the wire off the sensor. Try to determin which of the three wires is ground. Maybe brown? You can jump a wire from the ground to one of the other prongs.This could be the high or low speed. Do this from the ground ,to the remaining prong,too.Fan should run on both speeds. If you have a/c,try turning the a/c switch on. Even if your a/c is broken, the fan should run. You can put your sensor in a bucket of boiling water and test for continuity.Hot water will close the circut in the sensor. Try both speeds here. Your shark swims too fast .You passed my vanagon store right up,in the Washington dc area. Still, I have a fan with your name on it. Lot of hondas to eat around here. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.