Sounds about right to me. I'd guess the ohms measurement of the 12 volt element in the 1-2 ohms range, not zero but close by most standards. The 120 volt element, maybe 150 ohms, roughly. I've fixed a couple that had very dark connectors from overheating on the 12 volt wiring. I've never seen one that didn't work on 120 volts, but if used more in that mode failures would be more likely. I think many fridges unknowingly get left on 12 volts for years at a time, and the wiring ages from this, since the fridge is thus on whenever the engine is running. I have used Vasoline on the pump. Mark
nick greenaway wrote: > so i pulled my heater element from the fridge, and although i got a > big fat zero ohms resistance on the 12 volt side(i couldve tested it > wrong), i hooked the element up directly to my battery, and within > maybe a minute, it was REALLY hot.really really hot. havent hooked > up the 120v side yet. > i hope someone out there has experience fixin these, cuz i cant leave > this project alone, cant sleep, till i have closure on this one. im > hoping its just the previously mentioned blown fan motor is all thats > wrong. > > ................................................ |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.