< I used some of the new silicone self-curing tape on the split plastic tube SNIP -I'm sure there are a lot of problems it won't fix, but it's right up there with duct tape and baling wire in my book! I'd add JB "Quick Weld" to that must have list. My coolant level sensor cracked and spewed coolant on the last camping trip. I cursed leaving JB Weld home, but it was fate, I found JB Quick Weld with a much shorter curing time. I filled the inside of the sensor, put a spring clamp on that I had for tarp duty, put it in the sun on the dash board and went swimming for a couple of hours. Held on the way home a few trips around since then! John 86 VW-WWW (Wolfly Westy Weeneder) |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.