Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2006, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 10 Sep 2006 23:54:32 -0400
Reply-To:     Dennis Haynes <dhaynes@OPTONLINE.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <dhaynes@OPTONLINE.NET>
Subject:      Re: Electrical Chaos
Comments: To: John Rodgers <inua@CHARTER.NET>
In-Reply-To:  <450462BA.1070009@charter.net>
Content-type: text/plain; charset=US-ASCII

The PS pressure switch is just that, a simple switch. No polarity there.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of John Rodgers Sent: Sunday, September 10, 2006 3:09 PM To: vanagon@GERRY.VANAGON.COM Subject: Electrical Chaos

I have two 88 GL's. One red, one blue. The red one runs, the blue one doesn't - it's a project vehicle.

Ok, the High Pressure line off the power steering pump on my red van sprung a leak, so I needed to replace the line. Since it's the weekend, and getting any parts is always difficult on weekends. I exercised another option. I pulled the line - including the PS pressure switch - from the blue van and swapped it over.

Now you would think ..... two 88 GL's - everything is the same, right??? Wrong, at the least the wiring for the power steering pressure switch is different. On the blue van, both wires are white, no marks on the wires, no other identifiers, and no marks on the PS switch. On the red van, one wire is RW (red/White) the other is WY (White/Yellow). By Bentley the RW wire goes to Ground, and the WY goes to the Idle Stabilizer Control Unit (which is forward of the right hand tail light).

Question: Which wire goes to which terminal on the pressure switch. There are no marks on the switch - either the one I took off or the replacement. Since the two wires on the blue van were both white, it gives me no means for comparison to maybe solve the problem as to which goes where on the red van. The relative positions of the switchs are different enough that I cannot rely on what went before.

Does it matter which wire goes where??

Any input anyone may have to offer up would be much appreciated.

Thanks,

John Rodgers 88 GL Driver Chelsea, AL


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.